Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Install the control pedal to the body with the 3 nuts. Torque: 13 N·m {127 kgf·cm, 9 ft·lbf}

(b) Attach the wire harness clamp to the control pedal.

(c) Connect the parking brake switch connector.

2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Connect the parking brake cable to the control pedal.

(b) Using needle-nose pliers, slowly bend down the claw.

NOTICE:

Be careful not to damage the parking brake cable or claw.

(c) Install the clip to the control pedal.

(d) Temporarily install the adjustment nut and lock nut. HINT: The nuts will be tightened to a torque specification in the "ADJUST PARKING BRAKE PEDAL TRAVEL" procedure.

3. CHECK PARKING BRAKE PEDAL TRAVEL

4. ADJUST PARKING BRAKE PEDAL TRAVEL

5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page )

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL