Toyota Tundra Service Manual: Parking Brake Switch

Toyota Tundra Service Manual / Brake / Parking Brake / Parking Brake Switch

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. REMOVE PARKING BRAKE SWITCH ASSEMBLY

2. CHECK PARKING BRAKE SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Switch Condition

Specified Condition

1 - Switch body ground

Parking brake switch ON (Switch pin released)

Below 1 Ω

Parking brake switch OFF (Switch pin pushed in)

10 kΩ or higher

If the result is not as specified, replace the parking brake switch assembly.

3. INSTALL PARKING BRAKE SWITCH ASSEMBLY

    Removal

    Parking Brake System

    See More:

    Toyota Tundra Service Manual > Theft Warning Ecu: Removal
    REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here 2. D ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0386