DISASSEMBLY PROCEDURE 1. REMOVE GENERATOR PULLEY ![]() SST: 09820-63011 09820-06010 09820-06021
(a) Clamp the generator housing stay in a vise. (b) Install SST 1-A to the pulley shaft. (c) Install SST 1-B to SST 1-A. (d) Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque. Torque: 39 N·m {398 kgf·cm, 29 ft·lbf} NOTICE: Check that SST is secured on the rotor shaft.
(g) Remove SST 2 from the generator.
(i) Remove the pulley nut and pulley. 2. REMOVE GENERATOR REAR END COVER
(b) Remove the 3 nuts and end cover.
3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
4. REMOVE GENERATOR COIL ASSEMBLY
(c) Remove the generator washer. 5. REMOVE GENERATOR ROTOR ASSEMBLY 6. REMOVE GENERATOR DRIVE END FRAME BEARING
|
Toyota Tundra Service Manual > Intuitive Parking Assist System: Parts Location
PARTS LOCATION ILLUSTRATION *1 BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY *2 PARK/NEUTRAL POSITION SWITCH ASSEMBLY *3 NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH) *4 NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH) *5 NO. 2 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH) *6 NO. 2 ULTRASONIC SENSOR ...