REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER
2. DRAIN ENGINE COOLANT
3. REMOVE V-BANK COVER SUB-ASSEMBLY
4. REMOVE AIR CLEANER ASSEMBLY
5. REMOVE INLET RADIATOR HOSE
6. REMOVE FAN SHROUD
(b) Remove the fan and generator V-belt (See page ). (c) Disconnect the reservoir hose from the upper radiator tank.
(e) Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the fluid coupling fan. NOTICE: Be careful not to damage the radiator core. (f) Remove the fan pulley from the fan bracket. 7. REMOVE FAN
|
Toyota Tundra Service Manual > Starter(for 1.6 Kw Type): Inspection
INSPECTION PROCEDURE 1. INSPECT STARTER ASSEMBLY CAUTION: As a large electric current passes through the cable during this inspection, a think cable must be used. If not, the cable may became hot and cause injury. NOTICE: Perform each of the following tests within 3 to 5 seconds. (a) Perform a pull- ...