Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

(See page )

2. REMOVE FAN SHROUD

(See page )

3. DISCONNECT OUTLET RADIATOR HOSE

4. DISCONNECT RADIATOR SIDE DEFLECTOR RH

(a) Using a clip remover, remove the 3 clips and disconnect the radiator side deflector RH.

5. DISCONNECT RADIATOR SIDE DEFLECTOR LH

(a) Using a clip remover, remove the 3 clips and disconnect the radiator side deflector LH.

6. REMOVE RADIATOR ASSEMBLY

(a) Remove the 4 bolts and radiator assembly.

(b) Slide the clamp and remove the outlet radiator hose from the radiator assembly.

(c) Remove the radiator drain cock plug from the radiator assembly.

(d) Remove the O-ring from the radiator drain cock plug.

    On-vehicle Inspection

    Thermostat

    See More:

    Toyota Tundra Service Manual > Ultrasonic Sensor(for Rear Side): Inspection
    INSPECTION PROCEDURE 1. INSPECT NO. 2 ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 (BI) - 5 (EI) Always 10 kΩ or higher 1 (BI) - 2 (BO) Always 10 kΩ or higher 3 (SI) - 4 (SO) Always ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0128