Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.

PROCEDURE

1. REMOVE NO. 1 ENGINE UNDER COVER

2. DRAIN ENGINE COOLANT

3. REMOVE V-BANK COVER SUB-ASSEMBLY

4. REMOVE AIR CLEANER ASSEMBLY

5. REMOVE AIR TUBE SUB-ASSEMBLY LH

(a) Disconnect the 2 connectors.

(b) Disconnect the water by-pass hose.

(c) Disconnect the 2 wire harness clamps and air hose.

(d) Remove the bolt and disconnect the air tube LH from the water inlet housing.

(e) Disconnect the vacuum sensor connector and clamp.

(f) Remove the 2 bolts and disconnect the air hose from the air switching valve LH.

(g) Remove the air tube LH.

6. DISCONNECT OUTLET RADIATOR HOSE

(a) Disconnect the radiator hose.

7. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

(a) Remove the 3 nuts, water inlet with thermostat and gasket.

    Installation

    Water Pump

    See More:

    Toyota Tundra Service Manual > Meter / Gauge System: Engine Coolant Temperature Gauge Malfunction
    DESCRIPTION In this circuit, the combination meter receives the engine coolant temperature signals from the ECM using the CAN communication lines. The combination meter displays an engine coolant temperature that is calculated based on the data received from the ECM. WIRING DIAGRAM PROCEDURE 1. CHEC ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0092