Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FAN SHROUD

(See page )

2. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

(See page )

3. REMOVE NO. 1 WATER BY-PASS HOSE

(a) Remove the No. 1 water by-pass hose.

4. DISCONNECT NO. 8 WATER BY-PASS HOSE

(a) Disconnect the No. 8 water by-pass hose.

5. DISCONNECT NO. 5 WATER BY-PASS HOSE

(a) Disconnect the No. 5 water by-pass hose.

6. REMOVE WATER INLET HOUSING

(a) Remove the 3 bolts and water inlet housing.

(b) Remove the gasket from the water pump assembly.

7. REMOVE WATER PUMP PULLEY

(a) Using SST, hold the water pump pulley.

SST: 09960-10010

09962-01000

09963-01000

(b) Remove the 4 bolts and water pump pulley.

8. REMOVE WATER PUMP ASSEMBLY

(a) Remove the 8 bolts, water pump assembly and gasket.

Toyota Tundra Service Manual > Rear View Monitor System(for Radio And Display Type): Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Rear View Monitor System DTC Code Detection Item See page C1622 Open or Short Circuit in Back Camera Signal ...

Toyota Tundra Owners Manual