Toyota Tundra Service Manual: Installation

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Emission Control / Air Switching Valve(for Bank 1) / Installation

INSTALLATION

PROCEDURE

1. INSTALL AIR SWITCHING VALVE ASSEMBLY

(a) Install a new gasket and the air switching valve assembly with the 3 bolts.

Torque:

24 N·m {245 kgf·cm, 18 ft·lbf}

Text in Illustration

*1	Air Switching Valve Assembly
*2	No. 4 Air Tube
*a	Claw

NOTICE:

Make sure the gasket's claws are not caught between the air switching valve assembly and No. 4 air tube.

(b) Install the 2 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

Torque:

8.0 N·m {82 kgf·cm, 71 in·lbf}

2. CONNECT NO. 2 AIR HOSE

(a) Align the paint mark with the projection and connect the No. 2 air hose, and slide the clamp to secure the hose.

Text in Illustration

*a	Paint Mark
*b	Projection

HINT:

Make sure the direction of the hose clamp is as shown in the illustration.

(b) Connect the air switching valve assembly connector.

See More:

Toyota Tundra Service Manual > Sliding Roof: Sliding Roof Switch Assembly(for Crewmax)
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT SLIDE ROOF MOTOR SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 1 (UP) - 5 (E) Tilt switch is pressed to up Below ...

Toyota Tundra Service Manual: Installation

Inspection

Removal

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual