Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Emission Control / Air Switching Valve(for Bank 1) / Removal

REMOVAL

PROCEDURE

1. DISCONNECT NO. 2 AIR HOSE

(a) Disconnect the air switching valve assembly connector.

(b) Slide the clamp and disconnect the No. 2 air hose.

2. REMOVE AIR SWITCHING VALVE ASSEMBLY

(a) Remove the bolt and disconnect the wire harness clamp bracket from the cylinder head cover.

(b) Remove the 2 bolts.

(c) Remove the 3 bolts, air switching valve assembly and gasket.

NOTICE:

Be careful not to damage the installation surface of the gaskets.
    Installation

    Air Switching Valve(for Bank 2)

    See More:

    Toyota Tundra Service Manual > Rear Combination Light Assembly: Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL REAR COMBINATION LIGHT GUIDE HINT: If the rear combina ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0097