Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY
2. INSTALL EGR COOLER ASSEMBLY
3. INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY
4. CONNECT NO. 11 WATER BY-PASS HOSE
5. CONNECT NO. 8 WATER BY-PASS HOSE
6. INSTALL NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY
(b) Connect the No. 4 water by-pass hose. 7. INSTALL INTAKE MANIFOLD ASSEMBLY (a) Install the intake manifold (See page ). Removal REMOVAL PROCEDURE 1. REMOVE INTAKE MANIFOLD ASSEMBLY (a) Remove the intake manifold (See page ). 2. REMOVE NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY
(b) Disconnect the hose and remove the 2 bolts and No. 3 water by-pass pipe. 3. DISCONNECT NO. 8 WATER BY-PASS HOSE
4. DISCONNECT NO. 11 WATER BY-PASS HOSE
5. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
6. REMOVE EGR COOLER ASSEMBLY
7. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY
|
Toyota Tundra Service Manual > Differential Carrier Assembly(for 1ur-fe): Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY (a) Clean the contact surfaces of the rear differential carrier and the rear axle housing. (b) Install a new gasket and the differential carrier with the 10 washers and 10 nuts. Torque: 72 N·m {734 kgf·cm, 53 ft·lbf} NOTICE: Be ...