Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Emission Control / Egr Valve / Inspection

INSPECTION

PROCEDURE

1. INSPECT EGR VALVE ASSEMBLY

(a) Check the resistance of the EGR valve.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

20°C (68°F)

18 to 22 Ω

2 - 3

4 - 5

5 - 6

If the result is not as specified, replace the EGR valve.
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Steering Knuckle: Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH (a) Remove the front axle hub (see page ). 2. DISCONNECT FRONT SPEED SENSOR LH (a) Remove the clip and bolt. ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0283