Toyota Tundra Service Manual: Purge Valve

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Emission Control / Purge Valve

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT PURGE VSV

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	20°C (68°F)	23 to 26 Ω
1 - VSV body ground	Always	10 MΩ or higher
2 - VSV body ground	Always	10 MΩ or higher

If the result is not as specified, replace the purge VSV.

(b) Inspect the purge VSV operation.

(1) Check that air does not flow from ports.

(2) Apply battery voltage across the terminals.

(3) Check that air flows from ports.

If the result is not as specified, replace the purge VSV.

Installation

INSTALLATION

PROCEDURE

1. INSTALL PURGE VSV

(a) Install the purge VSV with the bolt.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

(b) Connect the connector.

2. CONNECT PURGE LINE HOSE

(a) Connect the 2 hoses.

HINT:

Turn the claw of the clip to the upper side.

3. INSTALL V-BANK COVER SUB-ASSEMBLY

Removal

REMOVAL

PROCEDURE

1. REMOVE V-BANK COVER SUB-ASSEMBLY

2. DISCONNECT PURGE LINE HOSE

(a) Disconnect the 2 purge line hoses.

3. REMOVE PURGE VSV

(a) Disconnect the connector.

(b) Remove the bolt and purge VSV.

See More:

Toyota Tundra Service Manual > Camshaft(for Bank 1): Removal
REMOVAL PROCEDURE 1. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY (a) Remove the timing chain cover (See page ). 2. SET NO. 1 CYLINDER TO TDC / COMPRESSION 3. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY LH (a) Move the stopper plate upward to release the lock, and push the plunger deep into the tensioner. (b) M ...

Toyota Tundra Service Manual: Purge Valve

Pcv Valve

1ur-fe Engine Control

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual