Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

  • Wear protective gloves when removing the exhaust pipe assembly.
  • The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  • Confirm that the exhaust pipe assembly has cooled down before removing it.

PROCEDURE

1. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(See page )

2. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

(a) Using SST, remove the air fuel ratio sensor.

SST: 09224-00010

3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

4. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

(a) Disconnect the air fuel ratio sensor connector.

(b) Using SST, remove the air fuel ratio sensor.

SST: 09224-00010

    On-vehicle Inspection

    Camshaft Oil Control Valve

    See More:

    Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Engine does not Start because No Initial Combustion
    DESCRIPTION When a key is inserted into the ignition key cylinder, the transponder key coil receives the key ID code and sends it to the transponder key ECU assembly. If an error in communication between the transponder key coil and transponder key ECU assembly occurs, this symptom may occur. WIRING ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0099