ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Start the engine and turn the tester ON. (c) Warm up the engine. (d) Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT Linear (Bank 1) or Control the VVT Linear (Bank 2) or Control the VVT System (Bank 1) or Control the VVT System (Bank 2) or Control the VVT Exhaust Linear (Bank 1) or Control the VVT Exhaust Linear (Bank 2). (e) Check the engine speed while operating the Oil Control Valve (OCV) using the tester. OK:
If the result is not as specified, check the oil control valve, wiring and camshaft timing gear. HINT:
|
Toyota Tundra Service Manual > Can Communication System: Millimeter Wave Radar Sensor Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Millimeter Wave Radar Sensor Communication Stop Mode Any of the following conditions are met: Communication stop for "Front Radar" is indicated on the "Communication Bus Check" screen of the Techstream. Click here Communication system DTCs (DTCs that s ...