Components COMPONENTS ILLUSTRATION  Installation INSTALLATION PROCEDURE 1. INSTALL CRANKSHAFT POSITION SENSOR  (a) Install the sensor with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (b) Connect the sensor connector. 2. INSTALL CRANKSHAFT POSITION SENSOR PROTECTOR
Removal REMOVAL PROCEDURE 1. REMOVE CRANKSHAFT POSITION SENSOR PROTECTOR
2. REMOVE CRANKSHAFT POSITION SENSOR  (a) Disconnect the sensor connector. (b) Remove the bolt and sensor. |
Toyota Tundra Service Manual > Rear Axle Shaft: Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE REAR WHEEL LH 2. DRAIN BRAKE FLUID 3. DISCONNECT REAR BRAKE FLEXIBLE HOSE (a) Disconnect the brake tube from the flexible hose with union nu ...
