Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor (See page ).

PROCEDURE

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:

Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor (See page ).

(a) Install a new gasket to the sensor.

(b) Using a 19 mm ball joint lock nut wrench, install the sensor.

Torque:

20 N·m {200 kgf·cm, 14 ft·lbf}

NOTICE:

Use the formula to calculate special torque values for situations where ball joint lock nut wrench is combined with a torque wrench (See page ).

2. ADD ENGINE COOLANT

3. INSPECT FOR COOLANT LEAK

4. INSTALL V-BANK COVER SUB-ASSEMBLY

5. INSTALL NO. 1 ENGINE UNDER COVER

Toyota Tundra Service Manual > Touch Select 2-4 And High-low System: Transfer Synchronization Actuator Circuit Open (P17A5,P17A6)
DESCRIPTION This DTC is detected when an open circuit or short to ground is detected in the solenoid coil drive circuit. DTC Code DTC Detection Condition Diagnosis Condition Malfunction Status Malfunction Time Other Trouble Area P17A5 Ignition switch ON (when not switching between 2WD and 4H) Open c ...

Toyota Tundra Owners Manual