REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER 2. REMOVE V-BANK COVER SUB-ASSEMBLY 3. DRAIN ENGINE COOLANT
4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR  (a) Disconnect the sensor connector. (b) Using a 19 mm ball joint lock nut wrench, remove the sensor. (c) Remove the gasket from the sensor. |
Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Engine Immobiliser System DTC No. Detection Item Link B2780 Push Switch / Key Unlock Warning Switch Malfunction B2784 Antenna Coil Open / Short B2793 Transponder Chip Malfunction B2794 Unmatched Encryption Code B2795 Unmatched Key Code B2796 No Communication in Immobili ...
