Toyota Tundra Service Manual: Fuel Pump Relay

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Engine Control / Fuel Pump Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. REMOVE FUEL PUMP RELAY (F/PMP)

(a) Remove the fuel pump relay from the engine room relay block.

2. INSPECT FUEL PUMP RELAY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	When no battery voltage is applied to terminals 1 and 2	10 kΩ or higher
3 - 5	When battery voltage is applied to terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the fuel pump relay.

3. INSTALL FUEL PUMP RELAY

(a) Install the fuel pump relay to the engine room relay block.

See More:

Toyota Tundra Service Manual > Seat Belt Warning System: Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be ...

Toyota Tundra Service Manual: Fuel Pump Relay

Removal

Heated Oxygen Sensor

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual