Toyota Tundra Service Manual: On-vehicle Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Engine Control / Heated Oxygen Sensor / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. CHECK HEATED OXYGEN SENSOR

(a) Disconnect the heated oxygen sensor connector.

(b) Measure the heater resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (HT1B) - 2 (+B)

(for Bank 1)

20°C (68°F)

11 to 16 Ω

1 (HT2B) - 2 (+B)

(for Bank 2)

If the result is not as specified, replace the heated oxygen sensor.

(c) Connect the heated oxygen sensor connector.

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Wf1am Transfer: 4wd Control Ecu
    ComponentsCOMPONENTS ILLUSTRATION InstallationINSTALLATION PROCEDURE 1. INSTALL 4 WHEEL DRIVE CONTROL ECU (a) Connect the 2 connectors. (b) Install the 4 wheel drive control ECU with the 2 bolts, and then tighten them in the order shown in the illustration. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0346