Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Engine Control / Heated Oxygen Sensor / Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

  • The procedures should be performed by at least 2 people.
  • Wear protective gloves when removing the exhaust pipe assembly.
  • The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  • Confirm that the exhaust pipe assembly has cooled down before removing it.

PROCEDURE

1. REMOVE PROPELLER SHAFT HEAT INSULATOR

2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

(a) Disconnect the heated oxygen sensor connector.

(b) Using SST, remove the heated oxygen sensor.

SST: 09224-00010

3. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

(a) Detach the 2 clamps and disconnect the heated oxygen sensor connector.

(b) Using SST, remove the heated oxygen sensor.

SST: 09224-00010

    On-vehicle Inspection

    Ignition Relay No. 2

    See More:

    Toyota Tundra Service Manual > Ignition Key Cylinder Light: Inspection
    INSPECTION PROCEDURE 1. INSPECT TRANSPONDER KEY COIL (IGNITION KEY CYLINDER LIGHT) (a) Apply battery voltage to the connector and check the light illumination condition. OK: Condition Specified Condition Battery positive (+) → Terminal 2 (ILL+) Battery negative (-) → Terminal 4 (ILL-) Illuminate ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0247