On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE INTEGRATION RELAY (a) Remove the engine room relay block cover.
(c) Disconnect the 3 connectors. 2. INSPECT INTEGRATION RELAY (IG2) NOTICE:
(a) Measure the resistance of the IG2 MAIN fuse. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the IG2 MAIN fuse.
3. INSTALL INTEGRATION RELAY (a) Connect the 3 connectors. (b) Install the integration relay to the engine room relay block. (c) Install the engine room relay block cover. |
Toyota Tundra Service Manual > Pre-collision System: Front Radar Sensor Beam Axis Not Adjusted (C1A14)
DESCRIPTION After installing a new millimeter wave radar sensor assembly, if sensor beam axis adjustment has not been performed, DTC C1A14 will be stored. DTC No. Detection Item DTC Detection Condition Trouble Area C1A14 Front Radar Sensor Beam Axis Not Adjusted When the vehicle is being driven at a ...