Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the manifold absolute pressure sensor. Installation INSTALLATION PROCEDURE 1. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR
(c) Connect the manifold absolute pressure sensor connector. 2. INSTALL V-BANK COVER SUB-ASSEMBLY
Removal REMOVAL PROCEDURE 1. REMOVE V-BANK COVER SUB-ASSEMBLY
2. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR (a) Disconnect the manifold absolute pressure sensor connector.
|
Toyota Tundra Service Manual > Automatic Transmission System: Output Speed Sensor Circuit No Signal (P0722)
DESCRIPTION The speed sensor SP2 detects the rotation speed of the transmission output shaft and sends signals to the ECM. The ECM determines the vehicle speed based on these signals. An AC voltage is generated in the speed sensor SP2 coil as the parking gear mounted on the rear planetary gear assem ...