Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL POWER STEERING OIL PRESSURE SWITCH (a) Install a new O-ring to the power steering oil pressure switch. (b) Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch. NOTICE:
(d) Connect the oil pressure switch connector. 2. INSTALL FAN AND GENERATOR V BELT (a) Install the fan and generator V belt (See page ). 3. ADD POWER STEERING FLUID 4. BLEED POWER STEERING FLUID
5. INSPECT FOR POWER STEERING FLUID LEAK 6. CHECK FLUID LEVEL
7. INSTALL FRONT FENDER APRON SEAL RH
8. INSTALL FRONT WHEEL
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT POWER STEERING OIL PRESSURE SWITCH (a) Check the oil pressure switch. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream main switch on. (4) Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering pressure. (5) Start the engine. (6) Operate the steering wheel while idling, and read the value on the Techstream. Standard:
If not as specified, check for DTCs (See page ). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch. Inspect the power steering system (See page ). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch. Removal REMOVAL PROCEDURE 1. REMOVE FAN AND GENERATOR V BELT (a) Remove the fan and generator V belt (See page ). 2. REMOVE FRONT WHEEL 3. REMOVE FRONT FENDER APRON SEAL RH
4. DRAIN POWER STEERING FLUID 5. REMOVE POWER STEERING OIL PRESSURE SWITCH
(b) Remove the power steering oil pressure switch. (c) Remove the O-ring. |
Toyota Tundra Service Manual > Power Window Regulator Motor(for Front Door): Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal ...