Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Engine Control / Throttle Body / Inspection

INSPECTION

PROCEDURE

1. INSPECT THROTTLE BODY ASSEMBLY

(a) Check the throttle valve.

(1) Check that the throttle valve opens and closes smoothly.

(2) Check that there is no sludge accumulating around the throttle body.

(b) Check the throttle control motor.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (M-) - 2 (M+)

20°C (68°F)

0.3 to 100 Ω

If the result is not as specified, replace the throttle body assembly.
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Rear Axle Shaft: Reassembly
    REASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not allow foreign matter, etc. to contact the ABS rotor bearing. PROCEDURE 1. INSTALL BRAKE DRUM OIL DEFLECTOR (a) Install a new deflector gasket and deflector to the rear axle shaft. HINT: Align the 2 oil drain holes. (b) Temporarily install a washer an ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0128