Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Engine Control / Throttle Body / Removal

REMOVAL

PROCEDURE

1. REMOVE NO. 1 ENGINE UNDER COVER

2. DRAIN ENGINE COOLANT

3. REMOVE V-BANK COVER SUB-ASSEMBLY

4. REMOVE AIR CLEANER HOSE ASSEMBLY

5. REMOVE THROTTLE BODY ASSEMBLY

(a) Disconnect the 2 water by-pass hoses.

(b) Disconnect the throttle position sensor and control motor connector.

(c) Remove the 4 bolts, throttle body and gasket.

(d) Remove the No. 12 water by-pass hose from the throttle body.

(e) Remove the No. 4 water by-pass hose from the throttle body.
    On-vehicle Inspection

    Vvt Sensor

    See More:

    Toyota Tundra Service Manual > Navigation System: Steering Pad Switch Circuit
    DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the navigation receiver assembly. If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly. If there is a short in the circuit, the same condition as when ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0043