Toyota Tundra Service Manual: Replacement

REPLACEMENT

PROCEDURE

1. REPLACE STRAIGHT PIN

NOTICE:

It is not necessary to remove the straight pin unless it is being replaced.

(a) Remove the straight pins.

(b) Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

Standard Straight Pin:

Item	Height	Width	Protrusion
Pin A	36 mm (1.42 in.)	10 mm (0.394 in.)	22 to 24 mm (0.866 to 0.945 in.)
Pin B	22 mm (0.866 in.)	10 mm (0.394 in.)	10.5 to 11.5 mm (0.413 to 0.453 in.)
Pin C	20 mm (0.787 in.)	8 mm (0.315 in.)	8.0 to 10.0 mm (0.315 to 0.394 in.)
Pin D	12 mm (0.472 in.)	4 mm (0.157 in.)	5.0 to 7.0 mm (0.197 to 0.276 in.)

Toyota Tundra Service Manual > Navigation System: Microphone Circuit between Microphone and Navigation Receiver Assembly
DESCRIPTION This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly. It also supplies power from the navigation receiver assembly to the telephone microphone assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIV ...

Toyota Tundra Owners Manual