Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL FRONT CRANKSHAFT OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

(b) Using SST and a hammer, tap in the oil seal to a depth between 0 to 1.0 mm (0 to 0.0394 in.) from the timing chain cover edge.

SST: 09223-22010

SST: 09506-35010

NOTICE:

  • Keep the lip free from foreign matter.
  • Do not tap the oil seal at an angle.

2. INSTALL CRANKSHAFT TIMING GEAR KEY

(a) Install the crankshaft timing gear key.

3. INSTALL CRANKSHAFT PULLEY

4. INSTALL OIL FILTER BRACKET

5. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

6. CONNECT COOLER COMPRESSOR ASSEMBLY

7. CONNECT FRONT STABILIZER BAR

(a) Connect the stabilizer bar and install the 2 stabilizer bushes and 2 stabilizer brackets with the 4 bolts.

Torque:

69 N·m {704 kgf·cm, 51 ft·lbf}

8. INSTALL FAN SHROUD

9. INSTALL FAN AND GENERATOR V BELT

10. INSTALL INLET RADIATOR HOSE

11. ADD ENGINE COOLANT

12. INSPECT FOR COOLANT LEAK

13. INSPECT FOR OIL LEAK

14. CHECK ENGINE OIL LEVEL

15. INSTALL NO. 1 ENGINE UNDER COVER

16. INSTALL V-BANK COVER SUB-ASSEMBLY

    Components

    Removal

    See More:

    Toyota Tundra Service Manual > Navigation System: How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the navigation system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. CUSTOMER PROBLEM ANALYSIS When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions s ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2022 Copyright www.ttundra.com
    0.0189