REMOVAL CAUTION / NOTICE / HINT CAUTION:
PROCEDURE 1. REMOVE HEATED OXYGEN SENSOR (See page 2. REMOVE TAILPIPE ASSEMBLY (a) Remove the bolt and clamp. (b) Disconnect the exhaust pipe support to remove the tailpipe assembly. (c) Remove the gasket. 3. REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the 4 bolts. (b) Disconnect the 3 exhaust pipe supports to remove the center exhaust pipe assembly. (c) Remove the 2 gaskets. 4. REMOVE FRONT EXHAUST PIPE ASSEMBLY (a) Remove the 3 nuts and front exhaust pipe assembly. (b) Remove the gasket. 5. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
6. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (a) Remove the 3 nuts. (b) Disconnect the exhaust pipe support to remove the front No. 2 exhaust pipe assembly. (c) Remove the gasket. 7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
Toyota Tundra Service Manual > Differential Carrier Assembly(for 3ur-fe, 3ur-fbe): Disassembly
DISASSEMBLY PROCEDURE 1. INSPECT RUNOUT OF REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY (a) Using a dial indicator, measure the runout of the companion flange vertically and laterally. Text in Illustration *a 72 mm (2.83 in.) Maximum runout: Runout Standard Condition Vertical runout 0.10 mm (0.00 ...