Components COMPONENTS ILLUSTRATION  Replacement REPLACEMENT PROCEDURE 1. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft (See page
2. REMOVE EXTENSION HOUSING REAR OIL SEAL  (a) Using SST, remove the oil seal. SST: 09308-00010 3. INSTALL EXTENSION HOUSING REAR OIL SEAL  (a) Coat the lip of a new oil seal with MP grease. (b) Using SST and a hammer, tap in the oil seal. SST: 09316-60011 09316-00011 09316-00051 Standard depth: 5.4 to 5.8 mm (0.213 to 0.228 in.) 4. INSTALL PROPELLER SHAFT ASSEMBLY (a) Install the propeller shaft (See page
5. ADD AUTOMATIC TRANSMISSION FLUID (a) Add automatic transmission fluid (See page
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Open in ABS Motor Relay Circuit (C146C)
DESCRIPTION The ABS motor relay supplies power to the pump motor. While the ABS is activated, the skid control ECU (brake actuator assembly) turns the ABS motor relay on to operate the pump motor. If the voltage supplied to the ABS motor relay (+BM) is too low due to low voltage from the battery or ...
).
