INSTALLATION PROCEDURE 1. INSTALL CRUISE CONTROL MAIN SWITCH
(b) Pass the cruise control switch wire under the rib as shown in the illustration. 
(c) Attach the guide. (d) Temporarily install the cruise control main switch with the 2 screws. (e) Tighten the 2 screws to install the cruise control main switch. HINT: Tighten the screws in the order shown in the illustration. (f) Connect the connector. 2. INSTALL STEERING PAD Click here 3. INSTALL LOWER NO. 3 STEERING WHEEL COVER Click here
4. INSTALL LOWER NO. 2 STEERING WHEEL COVER Click here 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 6. CHECK SRS WARNING LIGHT Click here |
Toyota Tundra Service Manual > Can Communication System: Open in One Side of Bus 3 Branch Line
DESCRIPTION If an ECU or sensor is not displayed on the "CAN Bus Check" screen of the Techstream and some ECUs and sensors repeatedly appear and disappear from the screen when the CAN main bus lines are normal (there is no open, short, short to +B or short to GND in the main bus lines), there may be ...
