Toyota Tundra Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Cruise Control / Trouble Codes.

(e) Check for DTCs.

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Cruise Control / Trouble Codes.

(e) Clear the DTCs.

    Diagnostic Trouble Code Chart

    Fail-safe Chart

    See More:

    Toyota Tundra Service Manual > Engine Unit: Inspection
    INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SET BOLT (a) Using a vernier caliper, measure the length of the cylinder head bolt from the seat to the end. Standard length: 141.3 to 142.7 mm (5.56 to 5.62 in.) Maximum length: 143.7 mm (5.66 in.) If the length is more than the maximum, replace the cyl ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0385