Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / Differential / Differential Carrier Assembly(for 3ur-fe, 3ur-fbe) / Removal

REMOVAL

PROCEDURE

1. REMOVE REAR WHEEL

2. REMOVE PROPELLER SHAFT ASSEMBLY

(a) Remove the propeller shaft for 2WD (See page ).

(b) Remove the propeller shaft for 4WD (See page ).

3. DRAIN DIFFERENTIAL OIL

4. REMOVE REAR AXLE SHAFT LH

(a) Remove the rear axle shaft LH (See page ).

5. REMOVE REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.

6. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

(a) Remove the 10 nuts, 10 washers and differential carrier.

NOTICE:

Be careful not to damage the contact surfaces of the differential carrier and rear axle housing.

(b) Remove the gasket.

Reassembly

Differential Carrier Oil Seal(for 1ur-fe)

See More:

Toyota Tundra Owners Manual > Steps to take in an emergency: If you think something is wrong
If you notice any of the following symptoms, your vehicle probably needs adjustment or repair. Contact your Toyota dealer as soon as possible. Visible symptoms Fluid leaks under the vehicle. (Water dripping from the air conditioning after use is normal.) Flat-looking tires or uneven tire wear Engin ...