DISASSEMBLY PROCEDURE 1. REMOVE FRONT NO. 1 LOWER ARM BUSH LH (a) Using a chisel and hammer, pry the flange of the bush outward.
2. REMOVE FRONT NO. 2 LOWER ARM BUSH LH (a) Using a chisel and hammer, pry the flange of the bush outward.
3. REMOVE FRONT NO. 1 SPRING BUMPER LH (a) Remove the No. 1 spring bumper from the vehicle. |
Toyota Tundra Service Manual > Power Seat Switch(w/o Seat Position Memory System): Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See pa ...