Toyota Tundra Service Manual: Data List / Active Test

Toyota Tundra Service Manual / Power Source, Network / Can Communication / Can Communication System / Data List / Active Test

DATA LIST / ACTIVE TEST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

DATA LIST

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Central Gateway / Data List.

(e) Read the Data List.

Tester Display

Measurement Item

Range

Normal Condition

IG2 SW

Ignition switch ON signal (IG2 terminal)

OFF or ON

OFF: Ignition switch ACC or off

ON: Ignition switch ON

IG1 SW

Ignition switch ON signal (IG1 terminal)

OFF or ON

OFF: Ignition switch ACC or off

ON: Ignition switch ON

ACC SW

Ignition switch ACC signal (ACC terminal)

OFF or ON

OFF: Ignition switch off

ON: Ignition switch ACC or ON

+B Voltage

Battery voltage (BATT terminal)

Over 8 V or Under 8 V

Over 8 V: Battery voltage 8 V or higher

Under 8 V: Battery voltage below 8 V

Number of DTC

Number of DTCs

0 to 255

Under 8 V: Battery voltage below 8 V
    Combination Meter ECU Communication Stop Mode

    Diagnosis System

    See More:

    Toyota Tundra Service Manual > Blind Spot Monitor System: Power Source Circuit
    DESCRIPTION This circuit provides power to operate the blind spot monitor sensor. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE 1. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH, BL ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0415