DTC CHECK / CLEAR CHECK FOR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes. (e) Read the DTCs. CLEAR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes. (e) Clear the DTCs. |
Toyota Tundra Service Manual > Engine Immobiliser System (w/o Smart Key System): Terminals Of Ecu
TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY (a) Disconnect the J26 transponder key ECU assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Tester Connection ...
