PRECAUTION 1. HANDLING PRECAUTIONS FOR STEERING SYSTEM (a)
The vehicle is equipped with an SRS (Supplemental Restraint System)
such as airbags. Failure to carry out service operations in the correct
sequence could cause the SRS to unexpectedly deploy during servicing.
This may cause a serious accident. Before servicing (including
inspection, replacement, removal and installation of parts), be sure to
read the precautionary notices for the Supplemental Restraint System
(See page 2. PRECAUTIONS FOR REMOVAL, INSTALLATION AND REPLACEMENT OF POWER STEERING COMPONENTS (a) Be sure to turn the front wheels straight ahead when removing and installing the power steering gear assembly. (b) If disconnecting the steering sliding yoke and the pinion shaft of the power steering link assembly, be sure to put matchmarks on them before starting the operation. |
Toyota Tundra Service Manual > Steering Knuckle: Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. PROCEDURE 1. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH (a) Remove the front axle hub (see page ). 2. DISCONNECT FRONT SPEED SENSOR LH (a) Remove the clip and bolt. ...
