Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL VANE PUMP ASSEMBLY

HINT:

Before performing the following procedures, move the spacer until the vane pump can be installed.

(a) Install the vane pump with the 2 bolts.

Torque:

28 N·m {286 kgf·cm, 21 ft·lbf}

2. CONNECT PRESSURE FEED TUBE

(a) Install a new gasket to the pressure feed tube.

(b) Install the pressure feed tube with the union bolt.

Torque:

51 N·m {520 kgf·cm, 38 ft·lbf}

3. CONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR

(a) Connect power steering oil pressure sensor connector.

4. CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

(a) Connect the pump hose with the clip.

5. CONNECT WIRE HARNESS CLAMP

(a) Connect the wire harness clamp.

6. INSTALL FAN AND GENERATOR V BELT

7. INSTALL AIR CLEANER ASSEMBLY

8. INSTALL V-BANK COVER SUB-ASSEMBLY

9. ADD POWER STEERING FLUID

10. BLEED POWER STEERING FLUID

11. INSPECT FOR POWER STEERING FLUID LEAK

12. INSTALL NO. 1 ENGINE UNDER COVER

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

Some systems need to be initialized after the cable is reconnected (See page ).

    Inspection

    Reassembly

    See More:

    Toyota Tundra Service Manual > Automatic Transmission System: 1-2 Shift (1-2 Shift Valve) (P0781)
    DESCRIPTION The 1-2 shift valve performs shifting to 1st gear and other gears. When shifting to 2nd and 4th gears is impossible, or when the ECM directs the transmission to switch to 5th or 6th gear and the engine overruns (clutch slips), this DTC is stored. DTC Code DTC Detection Condition Trouble ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0095