Toyota Tundra Service Manual: Outside Vehicle

General Maintenance

GENERAL MAINTENANCE

CAUTION / NOTICE / HINT

  • Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tools are not required. It is recommended that the owner perform these checks. The procedures for general maintenance are as follows.

PROCEDURE

1. GENERAL NOTES

  • Maintenance requirements vary depending on the country.
  • Check the maintenance schedule in the owner's manual supplement.
  • Following the maintenance schedule is mandatory.
  • Determine the appropriate time to service the vehicle using either miles driven or time (months) elapsed, whichever reaches the specification first.
  • Maintain similar intervals between periodic maintenance, unless otherwise noted.
  • Failing to check each vehicle part could lead to poor engine performance and increase exhaust emissions.

2. TIRES

(a) Check the tire pressure with a gauge. Make adjustments if necessary.

(b) Check the surfaces of tires for cuts, damage or excessive wear.

3. WHEEL NUTS

(a) Check for nuts that are loose or missing. Tighten them if necessary.

4. TIRE ROTATION

(a) Check the maintenance schedule in the owner's manual supplement.

5. WINDSHIELD WIPER BLADES

(a) Check the blades for wear or cracks when they are unable to wipe the windshield clean. Replace them if necessary.

6. FLUID LEAKS

(a) Check under the vehicle for leaking fuel, oil, water and other fluids.

NOTICE:

If you smell gasoline fumes or notice any leaks, locate the cause and correct it.

7. DOORS AND ENGINE HOOD

(a) Check that all of the doors operate smoothly, and that all the latches lock securely.

(b) When the primary latch is released, check that the engine hood secondary latch prevents the hood from opening.

    Inside Vehicle

    Under Hood

    See More:

    Toyota Tundra Service Manual > Front Upper Suspension Arm: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE FRONT SUSPENSION UPPER ARM BUSH (a) Using a hammer and chisel, strike and bend the entire flange of the upper arm bush as shown in the illustration. (b) Using SST and a press, press out the bush. SST: 09613-26010 SST: 09710-22021 09710-01031 SST: 09950-00020 2. REMOVE ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0097