Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY LH

(a) Check that the clearance measurements of areas A to J are within the standard range.

Standard measurement:

Area	Specified Condition	Area	Specified Condition
A	3.7 to 6.7 mm (0.146 to 0.264 in.)	F	0.8 to 3.8 mm (0.0315 to 0.150 in.)
B	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)	G	3.7 to 6.7 mm (0.146 to 0.264 in.)
C	3.7 to 6.7 mm (0.146 to 0.264 in.)	H	0.8 to 3.8 mm (0.0315 to 0.150 in.)
D	0.9 to 3.9 mm (0.0354 to 0.154 in.)	I	4.7 to 7.7 mm (0.185 to 0.303 in.)
E	3.7 to 6.7 mm (0.146 to 0.264 in.)	J	-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)

Toyota Tundra Service Manual > Vehicle Stability Control System: Brake Actuator Operation Sound is Loud during Initial Check
CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here PROCEDURE 1. PERFORM ROAD TEST (a) After turning the ignition switch to ON, compare the operating sound of the bra ...

Toyota Tundra Owners Manual