Toyota Tundra Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY LH

(a) Check that the clearance measurements of areas A to J are within the standard range.

Standard measurement:

Area

Specified Condition

Area

Specified Condition

A

3.7 to 6.7 mm (0.146 to 0.264 in.)

F

2.7 to 5.7 mm (0.106 to 0.224 in.)

B

-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)

G

3.2 to 6.2 mm (0.126 to 0.244 in.)

C

3.5 to 6.5 mm (0.138 to 0.256 in.)

H

2.8 to 5.8 mm (0.110 to 0.229 in.)

D

2.2 to 5.2 mm (0.0866 to 0.205 in.)

I

4.7 to 7.7 mm (0.185 to 0.303 in.)

E

3.2 to 6.2 mm (0.126 to 0.244 in.)

J

-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)

    Disassembly

    Reassembly

    See More:

    Toyota Tundra Service Manual > Front Door Lock(for Crewmax): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH 2. ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0107