Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH

for Double Cab:

(See page )

for CrewMax:

(See page )

2. REMOVE COWL SIDE TRIM BOARD LH

3. REMOVE INSTRUMENT SIDE PANEL LH

4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

5. REMOVE DECK LIGHT SWITCH ASSEMBLY

(a) Using a screwdriver, detach the 2 claws and remove the deck light switch assembly.

HINT:

Tape the screwdriver tip before use.

Text in Illustration

Protective Tape

    Installation

    Daytime Running Light Relay

    See More:

    Toyota Tundra Service Manual > Sfi System: Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P0051,P0052,P101D,P103D)
    DESCRIPTION Refer to DTC P2195 (See page ). HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the Air-Fuel Ratio (A/F) sensor. Sensor 1 refers to the sensor mounted in front of the Three-Way Catalytic Converter (TWC) and located near the engine assembly. When one of these DTCs is ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0092