Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Vehicle Interior / Lighting / Fog Light Assembly(for Led Fog Light) / Inspection

INSPECTION

PROCEDURE

1. INSPECT FOG LIGHT ASSEMBLY LH

(a) Apply battery voltage to the connector and check the light illumination condition.

OK:

Battery Connection

Specified Condition
If the result is not as specified, replace the fog light assembly LH.

Positive (+) → 2

Negative (-) → 1

Illuminates

*a

Component without harness connected

(Fog Light Assembly LH)

2. INSPECT FOG LIGHT ASSEMBLY RH

(a) Apply battery voltage to the connector and check the light illumination condition.

OK:

Battery Connection

Specified Condition
If the result is not as specified, replace the fog light assembly RH.

Positive (+) → 2

Negative (-) → 1

Illuminates

*a

Component without harness connected

(Fog Light Assembly RH)
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Steering Gear: Inspection
    INSPECTION PROCEDURE 1. INSPECT TIE ROD END SUB-ASSEMBLY LH (a) Secure the tie rod end LH in a vise. (b) Install the nut to the stud bolt. (c) Flip the ball joint back and forth 5 times or more. (d) Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the to ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0106