INSTALLATION CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. INSTALL HEADLIGHT ASSEMBLY LH
(a) Put protective tape around the headlight assembly LH. Text in Illustration
(b) Connect each connector and attach the clamp. (c) Attach the claw to install the headlight assembly LH. (d) Install the 2 screws and bolt. 2. INSTALL FRONT END PANEL LH
3. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
4. ADJUST HEADLIGHT AIMING (See page |
Toyota Tundra Service Manual > Vehicle Stability Control System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page. NOTICE: When replacing the skid control ECU (brake actuator assembly), senso ...