REMOVAL CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
2. REMOVE FRONT END PANEL LH
3. REMOVE HEADLIGHT ASSEMBLY LH 
(a) Put protective tape around the headlight assembly LH. Text in Illustration
(b) Remove the 2 screws and bolt. (c) Using a screwdriver, detach the claw. HINT: Tape the screwdriver tip before use. Text in Illustration
(d) Disconnect each connector, detach the clamp and remove the headlight assembly LH. |
Toyota Tundra Service Manual > Blind Spot Monitor System: Freeze Frame Data
FREEZE FRAME DATA 1. FREEZE FRAME DATA (a) Whenever a DTC is stored, the blind spot monitor sensor stores the current vehicle (sensor) state as Freeze Frame Data. 2. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) En ...
