Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Vehicle Interior / Lighting / Headlight Assembly(for Led Headlight) / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

2. REMOVE FRONT END PANEL LH

3. REMOVE HEADLIGHT ASSEMBLY LH

(a) Apply protective tape around the headlight assembly LH.

Text in Illustration

Protective Tape

(b) Remove the 2 screws and bolt.

(c) Pull the headlight assembly LH forward to detach the guide to remove it.

(d) Disconnect each connector and detach each clamp.

    Reassembly

    Headlight Dimmer Relay

    See More:

    Toyota Tundra Service Manual > Dynamic Radar Cruise Control System: Vehicle Information Not Obtained (C1A02)
    DESCRIPTION When a new millimeter wave radar sensor assembly is installed, it receives vehicle specification information (destination, steering wheel position, 2WD or 4WD, etc.) from the main body ECU (multiplex network body ECU) and stores the information. DTC C1A02 is stored when the millimeter wa ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0316