Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Vehicle Interior / Lighting / High Beam Main Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT AUTO HIGH BEAM SWITCH

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition
If the result is not as specified, replace the auto high beam switch.

6(+B) - (E)

Auto high beam switch ON

Below 1 Ω

Auto high beam switch OFF

10 kΩ or higher
Text in Illustration

*a

Component without harness connected

(Auto High Beam Switch)

(b) Check the illumination.

(1) Apply battery voltage to the connector and check the illumination condition.

OK:

Battery Connection

Specified Condition
If the result is not as specified, replace the auto high beam switch.

Positive (+) → 5(ILL+)

Negative (-) → 4(ILL-)

Illuminates
Text in Illustration

*a

Component without harness connected

(Auto High Beam Switch)
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Seat Belt: Tongue Plate Stopper
    Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. REMOVE TONGUE PLATE STOPPER (a) Slide the tongue plate above the installation position of the tongue plate stopper, and temporarily hold it with adhesive tape. (b) Remove any pieces of the original tongue plate stopper in the be ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0142