Toyota Tundra Service Manual: Customize Parameters

Toyota Tundra Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Customize Parameters

CUSTOMIZE PARAMETERS

PROCEDURE

1. CUSTOMIZE METER / GAUGE SYSTEM

(a) Customizing with Techstream

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Be sure to make a note of the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream ON.

(4) Enter the following menus: Customize Setting / Warning

(5) Select the setting by referring to the table below.

Warning

Display (Item)

Default

Content

Setting

Key Remind Sound

Slow

To change frequency of key reminder buzzer

Normal/Slow/Fast

Driver Side Seatbelt Warning Buzzer

ON

To change setting of driver side seat belt warning buzzer

ON/OFF

Front Passenger Side Seatbelt Warning Buzzer

ON

To change setting of passenger side seat belt warning buzzer

ON/OFF

(b) Customizing with the combination meter assembly

(1) Turn the engine switch on (IG).

(2) Enter the following menus: Settings.

  • Language
  • Units
  • Switch Settings
  • Drive Info 1
  • Drive Info 2
  • Pop-up display
  • Accent color
  • Default settings
    Open in Turn Signal Circuit (B1507,B1508)

    Data List / Active Test

    See More:

    Toyota Tundra Service Manual > Curtain Shield Airbag Assembly(for Crewmax): On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. CHECK CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (see page ). (b) With the curtain shield airbag installed on the vehicle, perform a visual check. If any of the defects mentioned below are present, repla ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0167