DESCRIPTION When the driver door key cylinder (key linked switch) is turned, the following occurs: 1) the door lock motor receives the signal; 2) the main body ECU (multiplex network body ECU) sends the signal to the power window regulator motors; and 3) the power window motors are activated. PROCEDURE
(a) Check for LIN communication system DTCs related to the power window control system. Click here OK: LIN communication system DTCs are not output.
(a) Check if DTC B2312 is output (See page ). OK: DTC B2312 is not output.
(a) Use the Data List to check if the door lock switch is functioning properly. Main Body
OK: On the Techstream screen, each item changes between ON and OFF according to above chart.
(a) Check that the manual UP/DOWN function using the master switch can operate the front door power window LH and RH (See page ).
|
Toyota Tundra Service Manual > Rear Axle Shaft: Installation
INSTALLATION PROCEDURE 1. INSTALL REAR AXLE SHAFT OIL SEAL (a) Using SST and a hammer, tap in a new oil seal. SST: 09950-60020 09951-00770 SST: 09950-70010 09951-07150 (b) Apply MP grease to the lip of the oil seal. NOTICE: Do not allow foreign matter, etc. to contact the axle shaft housing hole. 2. ...