Toyota Tundra Service Manual: Disc cannot be Ejected

Toyota Tundra Service Manual / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System / Disc cannot be Ejected

PROCEDURE

1.

PRESS "EJECT" AND CHECK OPERATION

(a) Press the disc eject switch of the navigation receiver assembly for 2 seconds or more and check that the disc is ejected.

OK:

Disc is ejected.

Result

Result

Proceed to

OK

A

NG (for Column Shift Type)

B

NG (for Floor Shift Type)

C
B

REPLACE NAVIGATION RECEIVER ASSEMBLY

C

REPLACE NAVIGATION RECEIVER ASSEMBLY

A

2.

REPLACE DISC WITH ANOTHER AND RECHECK

(a) Replace the disc with a known good one and check that the malfunction disappears.

OK:

Disc is ejected.

Result

Result

Proceed to

OK

A

NG (for Column Shift Type)

B

NG (for Floor Shift Type)

C
A

END (DISC IS DEFECTIVE)
B

REPLACE NAVIGATION RECEIVER ASSEMBLY

C

REPLACE NAVIGATION RECEIVER ASSEMBLY

    Diagnostic Trouble Code Chart

    Disc cannot be Inserted or is Ejected Right After Insertion

    See More:

    Toyota Tundra Service Manual > Rear View Monitor System(for Radio And Display Type): Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Rear View Monitor System DTC Code Detection Item See page C1622 Open or Short Circuit in Back Camera Signal ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0236