Toyota Tundra Owners Manual: Inside rear view mirror

The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view.

Adjusting the height of rear view mirror

The height of the rear view mirror can be adjusted to suit your driving posture.

Adjust the height of the rear view mirror by moving it up and down.

Anti-glare function

Manual anti-glare inside rear view m

Reflected light from the headlights of vehicles behind can be reduced by operating the lever.

  1. Normal position
  2. Anti-glare position

Auto anti-glare inside rear view mirror

Responding to the level of brightness of the headlights of vehicles behind, the reflected light is automatically reduced.

Changing automatic anti-glare function mode

ON/OFF

When the automatic anti-glare function is in ON mode, the indicator illuminates.

The function will set to ON mode each time the engine switch is turned to the "ON" position.

Pressing the button turns the function to OFF mode. (The indicator also turns off.)

■To prevent sensor error (vehicles with auto anti-glare inside rear view mirror) To ensure that the sensors operate properly, do not touch or cover the

■If a sun visor interferes with the mirror Hold and rotate the mirror to adjust the support.

Adjusting the steering wheel and mirrors

WARNING Do not adjust the position of the mirror while driving.

Doing so may lead to mishandling of the vehicle and cause an accident, resulting in death or serious injury.

    Steering wheel

    Outside rear view mirrors

    See More:

    Toyota Tundra Service Manual > Pre-collision System: System Diagram
    SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Millimeter Wave Radar Sensor Assembly Forward Recognition Camera Pre-collision alarm signal Pre-collision braking operation signal CAN Skid Control ECU (Brake Actuator Assembly) Brake assist standby signal Pre-collision braking operation ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0318